What HobbyCNC Fret Board is right for your guitar?
Start by comparing the part number on your board to the part numbers in the table below. If you don’t find a match, then find your guitar in the list below the table and double-check the “OEM” pc board against the images shown (click to enlarge).
NOTE: All boards are for WIRELESS guitars unless specified otherwise.
If your board looks like this, you need to order a GH-01.
– Mounting holes are the same size.
– Two, 4-wire connectors.
– SW2, 3 and 4 share a common line (highlighted in red).
If your board looks like this, you need to order a GH-03.
– Mounting holes are the same size.
– Two, 3-wire connectors.
– All switches share a common line (highlighted in blue).
If your board looks like this, you need to order a GH-14.
– Mounting holes are the same size.
– Two, 3-wire connectors.
– All switches share a common line (highlighted in red).
If your board looks like this, you need to order a GH-02.
– Mounting holes are different sizes.
– One, 8-wire connector
– SW2, 3 and 4 share a common line (highlighted in red).
If your board looks like this, you need to order a GH-04.
– Mounting holes are different sizes.
– Two, 3-wire connectors.
– All switches share a common line (highlighted in blue).
If your board looks like this, you need to order a GH-12.
– Mounting holes are different sizes.
– One, 6-wire connectors.
– All switches share a common line (highlighted in orange).
If your board looks like this, you need to order a GH-05.
– Mounting holes are slightly different sizes.
– One, 6-wire connector
– All switches share a common line (highlighted in purple).
If your board looks like this, you need to order a GH-04.
– Mounting holes are different sizes.
– Two, 3-wire connectors.
– All switches share a common line (highlighted in blue).