X axis bearing support

Welcome to HobbyCNC.com Forums DIY CNC Router Plans X axis bearing support

This topic contains 2 replies, has 3 voices, and was last updated by  hjmcnab 6 months, 3 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #4590

    Otis Almond
    Participant

    May be I just missed it but i can not find the location (measurements ) to mount the bearing support rails to the x axis sides. Distance from axis bottom board to bottom of bearing support.

    #4594

    BrianV
    Keymaster

    It’s easy to miss, there are so damn many dimensions to keep track of!
    It’s on Page 36 – “X-Axis Mounting Hole Detail, Sheet 2 of 3″, lower left, Detail A
    2 1/8” to the bottom of the dado from the bottom of the board.

    Send me photos of your progress for the Customer Builds page!

    Regards, BrianV

    #5451

    hjmcnab
    Participant

    Drawing 1016 shows drive rod snd ant-back lash running vertically. Should it not be horizontal?

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Pin It on Pinterest