- This topic has 0 replies, 1 voice, and was last updated 2 years, 10 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Ok whating to up grade so I can use windows 10 running a hobbycnc board 3 with mach3 if I go with warp9 I will have to stay with mack3 and really dont know how long it will be out if I go with uccnc I can run mach3 or uccnc software don’t know best way to go and will the uccnc work with hobbycnc board any help on this would be appreciated
Thanks
Roger
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.