CNC Build

HomePage › Forums › DIY CNC Router Plans › CNC Build

Tagged: 

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 20, 2016 at 6:39 pm #2938
    Joe Mahurin
    Participant

    My CNC Build. ~80% done. Still have to mount the anti-backlash and drive screws on the Y and Z axis. Install the stepper motors and rotozip and I am done.

    Attachments:
    December 21, 2016 at 12:45 pm #2948
    BrianV
    Keymaster

    Damn! Looks excellent. Congratulations – keep us updated!
    Regards, BrianV

    December 29, 2016 at 4:43 pm #2973
    Joe Mahurin
    Participant

    Got the steppers installed and tuned. I had a lot of trouble with the stepper motors binding up. Turned out I had cut the drive screws too long and they were binding up. All I got to do now is install/wire the limit switches, install the two tops, and build a cradle for my roto zip.

    Attachments:
    December 29, 2016 at 4:45 pm #2976
    Joe Mahurin
    Participant

    So to check how things were working I taped a felt tip pen to my z axis and ran the code to draw a 1″ square. It looks good!

    -Wesley

    Attachments:
  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest