Bleed Down Resistor

Welcome to HobbyCNC.com › Forums › Power supply questions › Bleed Down Resistor

This topic contains 1 reply, has 2 voices, and was last updated by  BrianV 6 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 28, 2017 at 3:09 pm #3078

    Larry Edinger
    Participant

    I’m using Two Capacitors, should I use a Resistor on each Capacitors?
    Thanks

    January 30, 2017 at 11:32 am #3164

    BrianV
    Keymaster

    Dear Larry,
    One bleed-down resistor is fine, you do not need one-per-cap.
    Regards, BrianV

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Pin It on Pinterest