- This topic has 1 reply, 2 voices, and was last updated 6 years, 2 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hello, I was just about to adjust the current on my 3 axis EZ driver board for the 305 stepper motors which I just ordered and are on their way. The product description for the 305’s says 3A but the mechanical drawing show 2A per phase. Do I want to adjust my driver board for 3A or 2A?
Dear Matthew,
Sorry for the delay. I found the problem, and what you reported is accurate.
Here’s the deal:
The motor I sell is now the 23-305-DS8A. I mistakenly uploaded the drawing for the old 23-305-DS8 (not the “A” version). The answer is 3A and it is now consistent between the product page and the mechanical drawing!
Good catch.
Regards, BrianV
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.