24v Fan control

HomePage › Forums › General HobbyCNC Questions › 24v Fan control

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 28, 2018 at 11:44 am #5343
    Steven Contella
    Participant

    Is the fan always on when the board has power or can it be turned on and off?

    Steve

    January 29, 2018 at 10:17 pm #5347
    BrianV
    Keymaster

    When the board is powered, the fan is on. There is no switching capability. You could add a switch manually, but if the board is powered, the driver chips are on-and-working and current is flowing through the motors.
    So: If the board is powered, YOU WANT THE FAN RUNNING!
    BrianV

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest