HobbyCNC PRO 3 & 4 Axis Board Assembly HomePage › Forums › HobbyCNC PRO 3 & 4 Axis Board Assembly This forum has 35 topics, 85 replies, and was last updated 8 months, 3 weeks ago by Peter Gregson. Viewing 16 topics - 1 through 15 (of 36 total) 1 2 3 → Topic Voices Posts Last Post Installing the Driver chips and Heatsink Started by: BrianV 1 1 2 years, 7 months ago BrianV Before you post . . . Started by: BrianV 1 1 4 years, 8 months ago BrianV What is pin 1 on the DB25 connector used for? Started by: Peter Gregson 2 4 4 months, 3 weeks ago BrianV Timing requirements for driving HobbyCNC Pro 4 Started by: Peter Gregson 3 4 9 months ago Peter Gregson Z Probe pin 15 Started by: Anonymous 2 2 10 months, 1 week ago BrianV Troubleshooting a 4 axis Pro assembly Started by: kmoorehouse 2 3 11 months ago kmoorehouse assembled pro boaed Started by: Anonymous 2 2 11 months, 2 weeks ago BrianV New pro board with GMFC Started by: Anonymous 2 3 12 months ago Anonymous E-Stop awareness Started by: Douglas Craig 3 6 1 year, 7 months ago Douglas Craig 4AUPC Rev 2 problem Started by: mamcubus 2 2 1 year, 10 months ago BrianV Current Adjustment Started by: David Bray 3 3 2 years, 3 months ago Anonymous troubleshooting preassembled board Started by: danb 2 4 2 years, 4 months ago BrianV Setting Up Mach3 Started by: Larry Edinger 2 2 2 years, 8 months ago BrianV Driving 2 motors for one axis Started by: BrianV 1 2 2 years, 10 months ago BrianV Home Wire Order Started by: Dennis Bird 1 2 2 years, 11 months ago Dennis Bird 5volt problem Started by: Samuel Davis 2 3 3 years, 8 months ago Samuel Davis Viewing 16 topics - 1 through 15 (of 36 total) 1 2 3 → You must be logged in to create new topics. Log In Username: Password: Keep me signed in Log In Log in / Register